Straight Marker

* 3x6x10 Gauge Main Wings

* 1" Hinge Pins

* Fits most Standard Tool Bars

* Single Acting Cylinder or Available with Double Acting Cylinder as Single Acting

M-10     Min 5'   Max 13-1/2'     332 lbs.

M-20    Min 9-1/2' Max 19-1/2'     396 lbs.

Measurements are from end of Bar to Disc

* 1-1/4" Hinge Pins

* Fits most Standard Tool Bars

* Available with Double or Single Acting Cylinder

HM-00  Min 8-1/2' Max 11'      536 lbs.

HM-0    Min 9-1/2' Max 13'     554 lbs.

HM-1     Min 11-1/2' Max 17'    590 lbs.

HM-2   Min 14-1/2' Max 21'     626 lbs.

HM-3   Min 18-1/2' Max 25'     661 lbs.

* This Marker Folds over for Better Clearance through Gates, Fences, etc.

* Safer Transporting

* 3x8x10 Gauge Main Wing

* 1-1/4" Hinge Pins

* Fits most Standard Tool Bars

* Use only with double acting cylinder

OM-00   Min 8-1/2'  Max 11'    552 lbs.

OM-0     Min 9-1/2'  Max 13'   570 lbs.

OM-1      Min 11-1/2' Max 17'   606 lbs.

OM-2     Min 14-1/2' Max 21'   650 lbs.

OM-3    Min 18-1/2'  Max 25' 685 lbs.

OM-4    Min 20-1/2'  Max 27' 700 lbs.

Measurements are from end of Bar to Disc

* Highly Successful Marking Disc

* Each Wing uses one 2x16 Cylinder

* Extreme Rigidity with Light Weight

* Adaptable to Almost any Size Toolbar

M-7   Min 8'  Max 14'   584 lbs.

M-8   Min 10'8"  Max 16'8"   624 lbs. 

Marker T-Bar

T-BAR ATTACH     9 lbs.

Disc & Clamps not Included

Marker Disc Assembly

MP-12     Mounted on 1" Shaft     15 lbs.

Used on all Roll-A-Cone Markers

Bearing #205PP11 or NPC100RPC

MP-12W     16 lbs.

Bearing #205PP11 or NPC100RPC

* Acts as a Small Gauge Wheel to Relieve Strain

* Uses Same Clamps as Disc Assembly

* Also Makes a Mark

* Mounted on 1" Shaft

     G-5     26 lbs.

* Use Clamp SH-2x2-1 to Mount Tire on Marker

* Light Duty Tire Wheel & Hub Mounted on 5/8x2" Shank

* 4.80x8 Tubeless Tire